KX2 Case

kx2 case

This is my KX2 case. It’s a Pelican 1200 case in vibrant orange so you can’t miss it out in the woods, unless it’s autumn in New England! Copyright 2018 Tim Carter

KX2 Case – For Durability Use a Pelican 1200 Case

My Elecraft KX2 is protected from damage because it fits snugly and securely inside a Pelican 1200 case. I don’t want my radio damaged if I slip and fall on a muddy or icy trail out in the wilderness.

kx2 case

This is an Elecraft KX2 inside a Pelican 1200 case. Just about everything you need to get on the air is in the case. Some of the gear I normally put in the case before I close it I left out for this photo. It would block what’s down in the foam cutouts. Copyright 2018 Tim Carter

What Fits in the KX2 Case?

I’m able to get the following into my Pelican 1200 Case:

Yes, all this fits in the case plus the radio! You just have to use the space wisely. Copyright 2018 Tim Carter

What Do the Cutouts Look Like?

kx2 case

The foam moves around when everything is out, but it goes back to the correct position when your stow the gear. Copyright 2018 Tim Carter

Will a KX3 Fit in a Pelican 1200 Case?

Yes, you can make an Elecraft KX3 fit into a Pelican 1200 case. It needs to be rotated 90 degrees so the long side of the radio is parallel with the case hinges.

You won’t be able to get into the case all the other goodies I’m able to stash with my KX2.

kx3 case

Here’s my KX3 sitting on top of the foam and other gear. You can’t see it from this angle, but there’s enough room on the sides for one row of the foam cubes. You might be able to stow the battery, unun, coax and power jumper cables, but that’s about it. Copyright 2018 Tim Carter

kx3 case

Jerry, W4DSD, contacted me about my KX2 in a case because he’s trying to get his KX3 to work in the same Pelican 1200 case. You can see there won’t be much room left for other stuff. Copyright 2018 Jerry W4DSD

pelican 1200 case

I wanted the bright orange so that no one steps on the case when I’m outdoors. If it had come with a flashing LED light, I would have bought that too! Copyright 2018 Tim Carter

 

3 thoughts on “KX2 Case

  1. I also use a pelican case, black, but I put reflective tape in two colors on all sides so I can spot with a flashlight in the dark if needed. I use a slightly larger case but get all my gear except the mast in there. I carry two batteries and two antennas. EFHW with balun and a SOTABEAMS dipole. KS3 and my Palm Paddles. About the same setup with the powerpole connectors and I have a small set of KOSS headphones I rigged with earfoam and a small speaker. Depending on where I am I can use the speaker too.
    de John Paul // AB4PP

Leave a Reply to Chris W Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.